![]() I very often find myself creating a new sketch, projecting geometry of interest onto it, and using that sketch for toolpath contours selection.sometimes the tricky part is to select the right contours.The pop-up help windows when you hover your mouse over any of the options are often quite helpful to remember what they do. I usually go through the tabs one by one and top to bottom (much faster once you get comfortable) to make sure I have everything covered. many of the options matter, and there are many in the various tabs of the toolpath menu.The error messages are relatively clear in that case. something wrong about the various heights being defined.I often have to reduce the helical ramping diameter for the tool to fit and the toolpath to be generated successfully. helical ramping) that combined with the tool diameter does not allow to mill the small sections of the model. using a tool that is too large for some of the features to be milled, or a material entry strategy (e.g. ![]()
0 Comments
Leave a Reply. |